Hot And Cold Hot Melt Adhesive
Hot Melt Adhesive are widely used for shipping rooms, school projects, manufacturing, construction and crafts. Thus making the industrial hot glue gun exceptionally flexible, and available for just about everything and in any kind of work field. There are also many various kinds of these guns, which can use different types of materials such as acrylic and plastic adhesives, as well as different kinds of glue sticks.
A cold heat adhesive gun uses cold melting adhesive sticks and they are sold in five/sixteen inch-diameters and four inch lengths, which can also glue up to 3m of materials, and have an adjustable nozzle, while industrial glues are purchased by companies and businesses as chips, bricks, dabs, dots and sticks as well as a hysol epoxy, which can be ideal for industrial use in most work places, while cold glue guns are best for just about anyone, including children, to use at home or at school.
The cold heat adhesive gun comes as a cordless, battery powered tool so that you can use it anywhere. The cold heat rechargeable glue gun has no cords which prevent you from moving around with it in hand, there is also no need to move your work area closer to an electrical point or to make a mess with extension cables. You can use the cold heat adhesive gun for everyday use around your household.
The hot and cold heat adhesive gun can be used as follows
• You need to find an electric power supply to plug your gun into, making sure it is placed securely, away from any wooden or carpet surfaces as well as anything flammable. The reason for this is that as the adhesive gun heats up, bits of adhesive might drip out the tip of the gun.
• The adhesive sticks need to be placed at the back of the gun. You should be sure that you have a spare stick of glue ready to be used.
• You then need to gather all the materials that you are wanting to adhesive while the gun heats up. The materials that work best are plastics, dried flowers, Styrofoam, thick fabrics, and wood. Thin papers, ceramics and fabrics aren't the best materials to use as a thick residue is left behind.
• You need to check that the glue has melted enough. To do this, you must squeeze the trigger lightly and place the tip of it against a sheet of paper. Easily dispersing the glue means that it is ready, yet if the trigger is hard to pull, then you will have to wait for a few minutes until the gun has heated up completely.
• Once the adhesive gun has heated up enough, and you have successfully tested it, you must pick up the gun and gently squeeze the trigger while drawing the lines on the material you wish to glue.
• Once you have drawn the lines on the material, you need to immediately place the other piece of material you wish to adhesive on to the lines you have drawn, pressing down firmly to ensure that the materials will stick together successfully.
• You have to then hold the two pieces of material together firmly for around fifteen seconds. After which you must remove one hand to test if the materials will hold together.
• Finally, you must then let the item set for several minutes in order to allow it to "cure". You will then have to use your fingernail or anything similar to scrape away the excess adhesive which is left behind.
© 2016 Pinghu Zhanpeng Hot Melt Adhesive Web & Film Co., Ltd. All Rights Reserved. Web support by : HWAQ