How to solve the problem of hot melt adhesive film foaming during lamination


We say that the factors that affect the bonding effect […]

We say that the factors that affect the bonding effect of casting hot fusible film mainly include two major links, such as selection and operation. The more common bonding problems are degumming, weak bonding, and bubbles after bonding. Degumming and weak bonding are likely to be a problem in the selection aspect. Bubbles after bonding are mainly caused by problems in the operation.


Tapes of nylon net hot melt adhesive with release paper for garment


Whether using hot-melt adhesive film bonding or using hot-melt mesh adhesive material, the main cause of blistering is that the air cannot be discharged. This situation is common in the application of non-breathable product materials such as films. Due to the non-air-permeable product materials like films, it is impossible to exhaust the backlog of air from the surface during bonding like non-woven materials.


Therefore, in the process of lamination, if the entire surface is pressed directly, the air in the middle is likely to cause a backlog, which is very easy to cause blistering after lamination. In view of this kind of foaming caused by air accumulation, the solution is to use a roller-type compound machine or iron to slowly heat and press the material from one side. In this way, the air in the middle can be continuously exhausted through the surroundings, and there will be no air accumulation and bubbling after bonding.


The cause of blistering after bonding is not only caused by the backlog of air that cannot be discharged, but also the blistering that may be caused by secondary heating. This situation is common in materials and industries that require a secondary composite process. The material usually does not foam during the first bonding, but because the second heating will use the hot melt film to melt again, if a certain pressure is not given, it will cause the product to foam.