What problems should be paid attention to during the processing of PET film


Nowadays, many Apertured Film processing places pay att […]

Nowadays, many Apertured Film processing places pay attention to the application of PET color film. Although this material is not much different from ordinary PET film in the production process, it is necessary to make the surface of the finished material have rich color effects. Adding different raw materials and using special process methods for processing, the film made in this way will produce different color effects through refraction during use.


PES Thermo Fusible Film for Automotive Interior

Color films are now widely used in packaging and decoration industries. Started to get affirmation from many users. So what issues should be paid attention to in the process of processing PET color film? Nowadays, many packaging industries need to print on the surface of the material when using color film, but the problem that needs to be paid attention to is that the temperature resistance of color film is relatively low, so during the processing of the material, if the temperature exceeds.


When the film can withstand the range, the film will begin to have quality problems such as wrinkles. Therefore, you must pay special attention to the temperature control during the processing of the film. This kind of film has a certain degree of elasticity, but if the tension is too large, the film cannot be restored to its original state, which will affect the actual application of the film.


Therefore, when processing the film At this time, you need to be careful not to use the film as an outer film, so that you can avoid quality problems caused by excessive tension.The PET color film produced today is also relatively weak to acid and alkaline substances, so be careful not to contact with corrosive substances during the use of the film.